TL;DR / Summary: Paint estimates go wrong because people measure wall area and forget to subtract doors and windows. Measure each wall, subtract the openings, divide by the coverage on the tin, and buy a little extra for the second coat.
Start with wall area, not room size
Room dimensions do not give you paintable area. Four walls have different widths, and some have large openings.
Measure each wall’s width and height separately, multiply, and add the results. This takes ten minutes and prevents the most common estimating error.
Include the ceiling if you are painting it, as a separate calculation. Ceilings are usually larger than people expect and often need a different paint.
Subtract the openings
Doors and windows are not painted, so their area comes off the total. A standard door is roughly 1.8 square metres; a window is often 1.5 to 2.
Be careful not to double-subtract. If you measured each wall including the openings, subtract them once. If you measured around them, do not subtract again.
- Standard door — about 1.8 m²
- Standard window — about 1.5–2 m²
- Patio doors — often 3–4 m²
- Fireplaces and alcoves — measure separately
Small openings, such as a hatch or a small vent, are usually not worth subtracting. The error is smaller than the uncertainty in coverage.
Trim and skirting
Skirting boards, door frames, and window trim are often painted in a different finish. Measure them by running length times height, and treat them as a separate paint purchase.
A rough rule for a standard room is one litre of trim paint per fifteen metres of trim, though the coverage on the tin is the authority.
Coverage varies more than the tin suggests
Tins state a coverage figure, usually around ten to twelve square metres per litre. That figure assumes a smooth, previously painted surface and a single coat.
New plaster absorbs far more. Bare plasterboard can take twice the paint of a previously painted wall on the first coat.
Textured surfaces increase the area and reduce coverage. A heavily textured wall may need half again as much paint as a smooth one.
Coverage figures assume a perfect wall. Most walls are not perfect.
Two coats, always
One coat is a touch-up, not a paint job. Plan for two full coats and calculate the paint accordingly.
If you are changing colour significantly, especially from dark to light, plan for three. The second coat will not fully cover a strong existing colour.
Primer is a separate purchase. New plaster needs a mist coat, and stain-blocking primer is needed where marks bleed through.
A worked example
A room with four walls: two at 4.2 by 2.4 metres, two at 3.6 by 2.4 metres. Total wall area is 20.16 plus 17.28, which is 37.44 square metres.
Subtract one door at 1.8 and two windows at 1.6 each, giving 4.9 square metres off, leaving 32.54 square metres.
At ten square metres per litre, one coat needs 3.25 litres, and two coats need 6.5 litres. Buy two 5-litre tins or one 10-litre tin, and keep the spare for touch-ups.
Buying the extra tin
Paint from a different batch can differ slightly in colour. Buying all the paint at once, from the same batch, avoids a visible mismatch on a wall painted in two sessions.
Keep a small amount of each colour for touch-ups. A labelled jar in a cupboard is worth more than a trip to the shop when a scuff appears.
Accounting for waste and error
Add ten percent to the calculated total. Roller trays, brushes, and spills consume paint, and a slight overestimate is cheaper than a mid-wall shortage.
If your measurement confidence is low, add fifteen percent. The cost of an extra tin is small compared with the cost of a colour mismatch from a second purchase.
For the arithmetic across several rooms, calculationassistant.com handles the multiplications quickly, though writing the wall dimensions down first is the step that prevents errors.
Paint estimating is simple arithmetic applied carefully. The care is in the measurement, and the arithmetic is the easy part.
Ceilings, trim, and the second visit
Ceiling area is length times width with no deductions. A typical bedroom ceiling is around twelve square metres, which is more paint than most people buy for a whole room.
Ceiling paint is usually a different product: flat, bright white, and splatter-resistant. Counting it in the wall total understates the purchase and produces a mid-job shortage.
Trim paint is a third product. Skirting, door frames, and window reveals take a surprising amount of paint because their surfaces are narrow and their edges are fiddly. A litre of trim paint goes less far than a litre of wall paint.
Storing leftover paint properly
Leftover paint is useful for touch-ups for years if it is stored correctly. Wipe the rim clean, seal the lid firmly, and store the tin upside down so the paint forms its own seal.
Keep it away from frost. Paint that freezes separates and cannot be reliably reconstituted, which is a common reason a stored tin fails when it is finally opened.
Label each tin with the room and the date. Three unlabelled tins of similar off-white are indistinguishable, and guessing wrong on a visible wall is worse than having no paint at all.


